Kohler K-6546-3-47 Installation Guide download pdf (Page 4)

1. Preparation

Install the water supplies and drain piping according to the

roughing-in information.

Undercounter Installations

Check to see if the faucet can be completely assembled to the

countertop and the sink.

Determine this by taking the countertop thickness plus the sink

rim thickness, 3/8” (1cm) plus or minus 1/32″ (1mm), and

comparing that measurement to the available shank length

between the base of the faucet assembly and the mounting nut. If

the available shank length is the same or longer than needed,

proceed. If not, select a thinner countertop or another faucet.

Tile-In Installations

Tile backer board installed over plywood is the recommended

underlayment for installing this sink. Tile should be bonded to

the backer board with dry set or latex Portland mortar.

Acceptable underlayments include:

•

Tile backer board over 3/4″ (1.9cm) exterior grade plywood

•

3/4″ (1.9cm) exterior grade plywood

IMPORTANT! Do not use:

•

Flakeboard

•

Interior grade plywood

•

Gypsum wallboard

Faucet Assembly

Mounting Nut

Sink Rim

Countertop

Thickness

1019950-2-B 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 39 40

No comments

Kohler K-6546-3-47 Installation Guide Page 4