Kohler K-6546-3-47 Installation Guide download pdf (Page 7)

3. Support Frame Installation

Tile-In Installations

This sink is designed to be installed ﬂush with or slightly lower

than the surrounding tile. Measure and compare the thickness of

the sink rim and tile. The rim thickness on this sink is 3/8” (1cm)

plus or minus 1/32” (1mm). Take these measurements into

consideration when determining support frame placement

(Dimension “H”). Because of the varying thickness of the tile and

sink, or if adhesive or mortar bed installation is used, you may

need to make allowances to shim the sink, or route the

underlayment as required.

Undercounter and Solid Surface Installations

Position the support frame in the cabinet opening so that when

installed, the top of the sink will be level and ﬂush with the top

of the cabinet (Dimension H).

All Installations

NOTE: Ensure that the securing hardware will not penetrate

through the cabinet walls.

Secure the support frame to the cabinet. Position the securing

hardware to allow for easy removal should the sink need to be

removed or replaced.

Apply Sealant

Water Supply Lines

Support Frame

Dimension "H"

Kohler Co. 7 1019950-2-B

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

No comments

Kohler K-6546-3-47 Installation Guide Page 7