Kohler K-12162-CP Installation Guide download pdf (Page 5)

4. Anchor Installation

NOTE: You may need to disassemble some of the accessories. Some

accessories will be packed with the wall plate installed in the post.

Loosen the setscrew and remove the wall plate if needed.

Press and hold the legs of a wall anchor (provided) together and

insert the wall anchor legs into the hole. Insert all wall anchors

into the pre-drilled mounting holes.

With a hammer, carefully tap each wall anchor until they are

ﬂush with the ﬁnished surface.

If the wall anchor was inserted into a space between the studs, it

will be necessary to spread the wall anchor legs.

To spread the anchor legs, insert a thin long object, such as a

ﬁnishing nail, into the wall anchor hole.

Repeat for all wall anchors inserted between studs.

Ensure that the wall anchors are ﬂush with the ﬁnished surface.

5. Wall Plate Installation

Orient the wall plate with the large slotted mounting hole down

and the smaller hole over the higher anchor.

Secure the wall plate with the supplied panhead screws.

Repeat at each wall plate location.

Kohler Co. 5 1013264-2-C

1 2 3 4 5 6 7 8 9 10 ... 35 36

No comments

Kohler K-12162-CP Installation Guide Page 5