Kohler K-487-CP Installation Guide download pdf (Page 11)

7. Install the Towel Bar

For [A] Length Bonnets

Partially thread the setscrew into each bonnet.

NOTE: The escutcheon sits loosely until the bonnet is in place and

the setscrew is tightened.

Slide the escutcheon onto the wall plate, if applicable.

Align the towel bar assembly over the wall plate.

Tighten the setscrew with a hex wrench.

For [B] Length Bonnets

IMPORTANT! Do not overtighten the setscrews. Overtightening can

damage the towel bar.

Use a hex wrench to thread a setscrew into each of the cylinder

heads and tighten. The detent on both cylinder heads should face

straight down.

Insert a cylinder head into each bonnet.

Insert a setscrew into both bonnets with a hex wrench. Tighten

the setscrews until the cylinder heads are secure against the

bonnets.

Classic Bonnet

Stately Bonnet

Setscrews

Towel Bar

Cylinder

Head

Setscrews

Shaft

Wall Plate

[A]

[B]

Kohler Co. 11 1020823-2-D

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

Kohler K-487-CP Installation Guide Page 11