Kohler K-487-CP Installation Guide Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
6. Install the Single Bonnet Accessories
For [A] Length Bonnets
Partially thread the setscrew into each bonnet.
NOTE: The escutcheon sits loosely until the bonnet is in place and
the setscrew is tightened.
Slide the escutcheon onto the wall plate, if applicable.
Align the accessory over the wall plate.
Tighten the setscrew with a hex wrench.
For [B] Length Bonnets
Loosen the setscrew in the bonnet until the cylinder head slides
out.
Slide the shaft of the cylinder head into the post.
Position the cylinder head with the detent facing downward.
Tighten the setscrew into the cylinder head with a hex wrench.
If needed, insert the tissue spindle into the tissue holder
assembly.
Setscrew
Shaft
Bonnet
Bonnet
Bonnet
Cylinder
Head
Tissue
Holder
Robe Hook
Setscrew
Spindle
Robe
Hook
Towel Ring
Detent
Wall Plate
[A]
[B]
Kohler Co. 9 1020823-2-D
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Comments to this Manuals

No comments