Kohler K-1913-R-96 Installation Guide download pdf (Page 23)

13. Install the Door

Installations Requiring Reassembly Only

NOTE: These steps are not required if the door was not removed in a previous step. If the door was not

removed, proceed to the ″Attach the Counterweights″ section.

Align the door and rollers on the drain side of the bath.

Pivot the other side of the door inward until the latch pins engage on both sides of the door.

Have the second installer hold the door up and position a 2x4 under the door, with the bottom end

of the 2x4 positioned on the subﬂoor (not the drip tray).

Slide the roller assembly up and partially into the door from below, making sure to feed the door

power cord back into the door.

If the bracket was removed, re-attach it to the roller assembly.

Reconnect the power cord to the door, then slide the roller assembly all the way up into the door.

If it is difficult to move the roller assembly into place, apply a small amount of lubricant. Loosen the

blue mounting brackets screws on one or both sides. Retighten the blue screws when the roller

assembly is in place.

Reinstall the cover plate on the base of the door and secure with the screw(s) previously removed.

Drain End

Align rollers on drain

side and swing door

in on an angle.

Swing other end of door

in place and attach.

Disconnect door

power cord.

Bottom View

Latch Pin

Strike Plate

Track for

Pulley Assembly

Proper Roller Alignment

Top View

Mounting Bracket

Install roller assembly.

Kohler Co. 23 1128532-2-C

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 135 136

No comments

Kohler K-1913-R-96 Installation Guide Page 23