Kohler K-1913-R-96 Installation Guide download pdf (Page 30)

Conﬁrm Operation and Check for Leaks (cont.)

Raise the door. Make sure the drain valve closes and the door inﬂates when the door latches.

IMPORTANT! Both limit switches must make contact for the seal to inﬂate. Do not over adjust.

Adjust the limit switch to make steady contact with the latch pin if needed. Consult the ″Adjust the

Limit Switch″ portion of the ″Adjust the Bath Door″ section for illustrations and instructions.

Close the footwell ﬂoor drain and ﬁll the bath with water to the overﬂow.

Check for leaks. Pay particular attention to the area around the door. There should be no indication

of leaking if no splashing or water movement is present.

If leaking is observed, drain the bath and clean any debris off the seal. Test for leaks again.

If leaking is still observed, adjust the door inward using the slots in the roller assembly.

Test again and continue these steps or consult the ″Troubleshooting Procedures″ section included in

this document.

Press the door switch and conﬁrm that the drain valve opens. Open the footwell drain.

When the water level falls below the level sensors in the footwell, conﬁrm the seal has deﬂated.

Squeeze the door handle and lower the door.

1128532-2-C 30 Kohler Co.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 135 136

No comments

Kohler K-1913-R-96 Installation Guide Page 30