Kohler K-1913-R-96 Installation Guide download pdf (Page 33)

19. Install the Finished Wall

All Installations

If you have not already done so, carefully remove any protective tape from the bath rim.

NOTE: Use the provided template (if needed) to cut the bottom of the wall material to match the contour

on the rear of the bath.

Cover the framing with water-resistant wall material. Seal the joints between the bath rim edge and

the water-resistant wall material with silicone sealant.

Tape and mud the water-resistant wall material. Install the ﬁnished wall to the water-resistant wall

material so it is 1/16″ (2 mm) above the bath surface. Seal the joints between the bath rim and the

ﬁnished wall material with silicone sealant.

Install the faucet trim according to the instructions packed with the trim.

20. Troubleshooting Procedures

This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualiﬁed

electrician should correct all electrical problems. For warranty service, contact your dealer or wholesale

distributor.

Normal Operation Includes:

While ﬁlling the bath with water, some water is routed to the drip tray and drain through

the accumulator drain hose. It is normal to see or hear a trickle of water either during or

immediately after ﬁlling. The accumulator is draining into the drip tray.

Caulk the seam of wall and bath.

Cut template.

Mark bath profile line on drywall.

Kohler Co. 33 1128532-2-C

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 135 136

No comments

Kohler K-1913-R-96 Installation Guide Page 33