Kohler K-3607 User Manual download pdf (Page 16)

Replacing the Pump (cont.)

Remove the lower rim hose clamp by sliding the clamping heads

apart.

Work the rim hose off the pump.

NOTE: The ﬂow restrictor slip ﬁts into the rim opening in the pump

and is held in place by the rim hose. When the hose is removed

from the pump, the restrictor may remain in the hose or on the

pump. Save the restrictor for reuse.

Use needle-nosed pliers to remove the ﬂow restrictor from the

rim hose or from the hose connection at the pump.

Inspect the lower rim hose for any damage. Replace if necessary.

Inspect the upper jet hose for any damage. Replace if necessary.

Install the Pump

Perform the following steps in order to install a new pump:

NOTE: The ﬂow restrictor slip ﬁts into the rim opening in the

pump, and is held in place by the rim hose.

Use needle-nosed pliers to insert the ﬂow restrictor in the rim

opening on the pump as shown.

Position the lower rim hose clamp on the rim hose.

Install the low rim hose on the pump.

Install the rim hose clamp by sliding the clamping heads together.

Position the upper jet hose clamp on the jet hose.

Position the pump in the tank and align it with the hose

connections.

Push the lower rim supply hose into the vitreous china hole.

Install the upper jet hose onto the pump.

Install the upper hose clamp by sliding the clamping heads

together.

Plug the modular plug and cord into the back of the ﬂush button.

Plug the electrical cord for the toilet into the outlet.

NOTE: Use the proper termination devices as required by any local

electrical codes.

Turn on the water.

Observe that the tank reﬁlls.

1092035-5-A 16 Kohler Co.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 75 76

No comments

Kohler K-3607 User Manual Page 16