113169-2-EB 2001 Kohler Co.
BARRINGTON
PRESSURE LITE
VITREOUS CHINA
SIPHON JET TOILET
K-4327
BEFORE YOU BEGIN
INSTALLER HAZARD NOTIFICATION
WARNING: Risk of injury or water damage.
Contents of vessel under pressure can cause
severe injury. Do not open or service before reading
installation instructions or service instructions. Turn
off water supply and flush unit to release pressure
before attempting any service.
CAUTION: Risk of product damage. Do not use
any oils or lubricants on the Pressure Lite system.
CAUTION: Risk of product damage. The fittings
in this toilet require no adjustment (except for
possible gap clearance adjustment and winterizing,
refer to Page 6). The fittings in this toilet are preset.
Any adjustment or modifications of the product are
not normal usage and void the warranty.
WARNING: Risk of injury or product damage.
Handle vitreous china products very carefully.
Vitreous china can break and chip if you overtighten
bolts and nuts.
NOTICE: For service and warranty on the Sloan
Flushmate vessel and related components, see the Sloan
Flushmate Owner’s Service Manual (included). Follow
all local plumbing codes.
PRODUCT PROPERTIES
Pressure Lite System.
Water surface to rim is 6-7/8” (17.5cm).
2-1/4” (5.7cm) passageway.
For roughing-in and overall dimensions, see
roughing-in diagram on Page 2.
Fixture dimensions are nominal and conform to
tolerances by ANSI/ASME Standards (A112.19.2).
NOTICE: Due to the pressure within the vessel, the flush
noise level may be higher than that of a gravity flush toilet.
PRODUCT REQUIREMENTS
The supply stop should be 8” (20.3cm) above the
floor line, and 7” (17.8cm) to the left of the closet
flange centerline.
Since all toilets do not have the same supply
rough-in, you may have to change the location of
the supply stop to install this toilet.
Closet flange must be 4” (10.2cm) on-center from
floor.
Seat post holes are on 5-1/2” (14.2cm) centers.
For most satisfactory operation, the toilet requires
20 p.s.i. (1.3Kg/cm)static pressure minimum at
the supply stop. The pressure is not to exceed 80
p.s.i. (5.5Kg/cm) maximum static pressure.
ORDERING INFORMATION
Toilet K-3546. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
When specified:
3/8” supply K-7637. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Floor bolts 21401. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
NOTE: .For service parts ordering information, see the
label on the underside of the tank cover.
NOTICE: For service and warranty on the Sloan
Flushmate vessel and related components, see the Sloan
Flushmate Owner’s Service Manual (included).
MATERIALS REQUIRED
Supply stop (3/8” recommended)
Toilet gasket (wax seal)
Toilet T-bolts 1/2” (6mm) or 5/16” (8mm) diameter
(2 required)
Toilet supply tubing
TOOLS REQUIRED
Tape measure
Screwdriver
TOOLS REQUIRED
10” adjustable wrench
Tubing cutter
Hacksaw
Level
Putty knife
Metal file
NOTE: Site preparation may require additional tools.
Comments to this Manuals