Kohler K-4327-0 Installation Guide download pdf (Page 2)

113169-2-EB

Kohler Co., Kohler, WI U.S.A

SITE PREPARATION

REMOVE EXISTING TOILET

NOTICE: Carefully inspect new fixture for any sign

of damage before removing existing toilet. If any

damage to vitreous china or Pressure Lite system

components are discovered, stop installation and call

place of purchase for assistance.

Inspect the complete toilet to ensure that the:

 Components are attached securely.

 Trip lever and plunger arm move freely.

 Vessel is securely mounted.

 Vitreous china is undamaged.

Turn off the water supply.

Flush the toilet, and sponge out all remaining water from

the tank and bowl.

Disconnect the supply stop, and remove the old tank and

bowl.

Remove the old gasket from the wall and outlet flange with

a putty knife.

Remove the old T-bolts (the T-shaped bolts in the closet

flange), and discard.

CAUTION: Risk of hazardous gases. If the new

toilet is not installed immediately, temporarily stuff

a rag in the closet flange.

ROUGH-IN PLUMBING

Turn off the water supply.

Install or relocate the supplies and outlets as necessary

to conform to the roughing-in dimensions.

CAUTION: Risk of trap seal loss in

back-to-back installations. To prevent possible

trap seal loss, the back-to-back Pressure Lite toilet

must be connected to a vertical stack using one of

the following three fittings:

 Double fixture fitting

 Double combination wye and 1/8 bends

 Double wye and 1/8 bends

Double

Fixture

Fitting

Double

Combination

Wye and 1/8

Bends

Double Wye

and 1/8

Bends

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Kohler K-4327-0 Installation Guide Page 2

Comments to this Manuals