Kohler K-4327-0 Installation Guide Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
4
113169-2-EB
Kohler Co., Kohler, WI U.S.A
SECURE TOILET
Carefully align and set the toilet into position, ensuring
that all gasket installation instructions are followed.
Tighten the wall bolts, ensuring proper gasket seal.
Install 1/4” (6mm) floor-mounting bolts. Assemble the bolt
cap bases, washers, and nuts. Hand-tighten the nuts,
then tighten them an additional 1/2-turn with a wrench.
CAUTION: Risk of personal injury or product
damage. Overtightening may cause breakage or
chipping of the vitreous china.
If the floor bolts extend more than 1/4” (6mm) from the top
of the nut, loosen the nut and turn the bolt further into the
floor. Retighten the nut, and install the bolt caps.
Bolt Cap
Nut
Washer
Bolt Cap
Base
INSTALL TANK
Set the tank on the bowl, using the bolts as a guide. Center
the gasket on the inlet of the bowl.
Assemble the washers and brass hex nuts onto the bolts,
and hand-tighten evenly.
Alternately tighten the brass hex nuts so the top of the
tank is level with the top of the bowl. Pushing down on the
top of the tank will make it easier to tighten the brass hex
nuts.
Tighten the brass hex nuts one or two turns past hand tight
to obtain a level tank and watertight seal.
CAUTION: Risk of personal injury or product
damage. Overtightening may cause breakage or
chipping of the vitreous china.
Tank Bolt
Gasket
CONNECT SUPPLIES
Carefully bend the supply stop tubing to fit. Measure for
required penetration into the supply stop. Cut and de-burr
the tubing. Install the connection hardware onto the tubing
as shown. Hand-tighten the coupling nut first, and then
the compression nut.
WARNING: Risk of property damage. Do not
overtighten or you may deform the connections and
cause a leak. Do not use tools to tighten plastic
nuts.
Supply Stop
Ferrule
Compression
Nut
Coupling Nut
Tubing
Washer
Supply Shank
PRESSURE LITE SYSTEM
WARNING: Risk of personal injury or water
damage. Contents of the vessel are under
pressure, and can cause severe injury. Do not open
or service before reading installation instructions or
service instructions. Turn off the water supply, and
flush the unit to release pressure before attempting
any service.
CAUTION: Risk of product damage. Do not use
any oils or lubricants on the Pressure Lite system.
Page view 3
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments