Kohler K-4327-0 Installation Guide Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
5Kohler Co., Kohler, WI U.S.A
113169-2-EB
OPERATION
The vitreous china bowl and tank direct the flushing water
flow, and house the Pressure Lite system.
The vessel contains the complete operating cartridge
assembly, and is the container for the pressurized 1.6
gallons (6.1 L) of water used for each flush.
The control components consist of the pressure regulator
and the air inducer. These components work with the
incoming, pressurized, supply-line water to provide a
regulated pressure flush to the toilet bowl.
A complete flush cycle is two separate functions.
When the trip lever is operated, the vessel plunger
assembly is pressed, allowing pressurized water to be
directed to the bowl for complete flushing action. As the
water level in the vessel drops the plunger will close,
stopping water flow to the bowl.
A checkport built into the vessel assembly allows any
discharge of water into the vitreous tank to drain directly
into the bowl.
After flushing, a charge cycle takes place. Supply line
water flows into the vessel through the screen and
pressure regulator. The water then flows across the air
inducer, which mixes a small amount of air with the water,
filling the vessel until a pressure of approximately 35 p.s.i.
(2.5Kg/cm) is reached. The toilet will be ready for the
next flush within 60 to 90 seconds. If the toilet is not ready
for the next flush within that time, please refer to the
troubleshooting chart on Page 7.
Pressure
Regulator
Air Inducer
Actuator
Vessel
Water
Air
Trip
Lever
Overflow Valve
Screen
Supply
Hose
START-UP
Turn on the water supply to bring the Pressure Lite system
to its operating pressure (approximately 1 minute).
Check for leaks. Slight retightening of any leaking
connections should stop seal leaks.
If the toilet is leaking between the tank and bowl, carefully
retighten the three tank bolts evenly. Check all bowl and
tank connections for leaks for several days.
Flush and repressurize the toilet three times to stabilize
the system.
Page view 4
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments