Kohler K-4327-0 Installation Guide Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
6
113169-2-EB
Kohler Co., Kohler, WI U.S.A
GAP CLEARANCE
If the toilet does not activate, the gap between the
actuator and plunger arm may need to be reset. Make
sure the trip lever handle is installed, and the trip lever nut
is tight. This is a left-hand thread; turn counterclockwise
to tighten.
Make sure the water supply is on, and the supply line
water has stopped flowing into the toilet.
Loosen the setscrew. Turn the actuator until there is a
1/16” (2mm) – 3/32” (2.4mm) gap between the actuator
and the plunger arm. Turn the actuator clockwise to
increase the gap. Tighten the setscrew after the gap is
properly adjusted.
NOTE: Loss of gap clearance adjustment could cause
leakage into the toilet bowl due to the plunger not sealing
properly. This condition could cause a continual flow of
water. If the problem is not corrected after adjustment,
refer to the troubleshooting chart on Page 7.
Actuator
Gap Adjustment
1/16” (2mm) – 3/32” (2.4mm)
Plunger Arm
Setscrew
INSTALL SEAT
To install, use the seat attachment hardware and
instructions packed with the toilet seat.
MAINTENANCE
WINTERIZING
Shut off the water supply.
Flush the toilet. Press the actuator down for
approximately one minute to drain water from the vessel
assembly.
Disconnect the supply line.
Remove the supply shank, and drain the water from the
tank.
Press the actuator one more time, then pull it up to allow
air into the vessel.
Add antifreeze to the toilet bowl water to prevent freezing.
Use recreational-type antifreeze commonly used in
campers, motor homes, and boats.
For start up, connect water supply and refer to the
Start-Up section on Page 5.
NOTE: Refer to the Sloan Flushmate Owner’s Service
Manual (included) for more information.
Pressure
Regulator
Air Inducer
Actuator
Vessel
Trip
Lever
Overflow Valve
Screen
Supply
Hose
Page view 5
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments