Kohler Bath Whirlpool K-812-N1 User Manual download pdf (Page 5)

Operation

NOTE: If the whirlpool is not operating properly, consult the ″Troubleshooting″ section of this guide

before calling a qualiﬁed service representative.

Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.

NOTICE: Do not allow the water temperature in the whirlpool to exceed 104°F (40°C). The heater will

automatically maintain the water temperature when the whirlpool is running, as long as the water

temperature does not exceed 104°F (40°C). The heater will disengage at higher temperatures.

Close the drain, then ﬁll the whirlpool to a level at least 2″ (5.1 cm) above the highest jet. Using

your hand, test the water temperature for comfort and safety. Carefully enter the bath.

Press the power icon to turn on the whirlpool pump and heater. Water will ﬂow at medium volume.

Press the up or down arrow icons to increase or decrease the water ﬂow. The indicator bar will

display the water ﬂow volume.

Adjust the jets for optimum air/water mixture. Turn the jet trim clockwise to reduce the ﬂow or

counterclockwise to increase the ﬂow. If desired, position the jet nozzles to direct the water ﬂow to

maximize your hydro-massage experience.

If desired, turn the heater off by pressing the heater icon. Press the button a second time to turn the

heater back on.

Press the power icon a second time to turn off the whirlpool pump and heater.

NOTE: The pump and heater will automatically stop after approximately 20 minutes of continuous

operation. If desired, press the power icon to reactivate the pump and heater.

Carefully exit the bath, then open the drain to empty the whirlpool.

Neckjets

NOTE: Before activating the neckjets, make sure the slip cover is in place on the pillow and the pillow is

attached to the neckjet body. If the pillow is not properly installed the neckjets will stop. The neckjet icon

and indicator bar on the user keypad will ﬂash. The neckjets will automatically restart when the pillow is

properly installed.

Rotate the outer ring to select the neckjet mode, then press OK to activate the neckjets. The neckjet

pulsing action will start at medium speed. Press the up or down arrow to adjust the pulsing action.

Rotate the outer ring until the ﬂow mode is ﬂashing, the press OK. Press the up or down arrow to

adjust the water ﬂow volume of the neckjets.

Press ″OK″ while the neckjet mode is active, to turn off the neckjets.

Fill with water at least 2" (5.1 cm)

above the highest jet.

Turn the jet trim ring

clockwise to

decrease the flow.

Position the jet

nozzles to direct

the water flow as

desired.

Turn the jet trim ring counterclockwise

to increase the flow.

Kohler Co. 5 1019490-5-C

1 2 3 4 5 6 7 8 9 10 ... 55 56

No comments

Kohler Bath Whirlpool K-812-N1 User Manual Page 5