Kohler Bath Whirlpool K-870 User Manual download pdf (Page 5)

1019486-5-A

Kohler Co.

Turn the jet trim

ring clockwise to

decrease the flow

Turn the jet trim ring

counterclockwise to

increase the flow

Lighted User Keypad

Heater

On/Off

Increases

Flow

Decreases

Flow

Power

On/Off

Indicator Bar--

Shows water

flow volume

Heater Indicator

Light

User Keypad and Whirlpool Modes/Features

S Power- Turns the whirlpool pump on and off.

S Up Arrow- Increases the water flow.

S Down Arrow- Decreases the water f low.

S Heater- The heater automatically engages when the whirlpool is turned on. You may turn the heater off by

pressing the heater button. Press the button a second time to turn the heater back on.

S Indicator Bar- Shows the water flow volume.

Optional Remote Control

If you purchased a remote control, please refer to the Homeowners Guide packed with your remote control for

detailed information.

Operating Your Whirlpool

- Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.

NOTE: The water temperature in the whirlpool should never exceed 104_F(40_C). A built-in heater automatically

maintains the water temperature when the whirlpool is running, as long as the water temperature does not

exceed 104_F(40_C). The heater will disengage a t higher temperatures.

- Close the drain, and fill the whirlpool to a level at least 2” (5cm) above the top of the highest jet. Use your hand to

test the water temperature for comfort and safety, then carefully enter the bath.

- Press Power to turn on the whirlpool. The whirlpool will start at medium volume. The heater will also turn on

and the heater icon will illuminate.

- Increase or decrease the water flow by pressing the up or down arrows on the keypad. An indicator bar in the

center of the keypad shows the water flow volume.

- Adjust the jets for optimum air/water mixture. Turn the jet trim clockwise to reduce the flow, and

counterclockwise to increase the flow. Position the jet nozzles to direct the water flow as desired to maximi ze your

hydro-massage experience.

- The heater automatically engages when the whirlpool is turned on. You may turn the heater off by pressing the

heater button on the keypad. Press the button a second time to turn the heater back on.

- Press Power a second time to turn off the whirlpool.

NOTE: Your whirlpool will automatically stop after approximately 20 minutes of continuous operation. You can

restart the whirlpool, if you desire, by pressing Power.

- Carefully exit the bath, and open the drain to empty the whirlpool.

NOTE: If the whirlpool does not function properly, please refer to Troubleshooting on Page 10.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments

Kohler Bath Whirlpool K-870 User Manual Page 5

Comments to this Manuals

Related products and manuals for Water equipment Kohler Bath Whirlpool K-870