Kohler Freewill Barier Free Bath Whirlpools K-12106-H User Manual download pdf (Page 10)

115982-2-BA (-)

Kohler Co., Kohler, WI

7. INSTALL THE WHIRLPOOL

A. WHIRLPOOL SET-IN

1. Lay out and mark the supply or mixing valve hole

locations on the back of the unit. Drill a 1/4”

diameter pilot hole at each fitting mark.

2. For multiple-unit installations, where the supply

fittings have been accurately located during the

plumbing rough-in, a template made of lightweight

plywood and containing all the correct pilot holes

can be used to position the holes on the back

surface of the unit.

3. Use a hole saw to drill the holes required. Drill from

the finished face of the unit.

CAUTION: Risk of product damage. When

moving the unit, do not flex or damage may occur.

4. Clean the bath recess thoroughly. Carefully slide

the unit into the recess.

5. Use a level to plumb and level the unit. Be sure the

bottom of the unit is firmly supported against the

floor. Use shims as needed. Some framing

adjustments may be necessary. No additional

support is necessary.

6. Attach the unit to the 2x2 brace and toe plate

previously installed around the recess rough

opening.

7. Use #6 large-head galvanized nails or #8 x 1” sheet

metal screws across the top and bottom, and up

both sides.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Kohler Freewill Barier Free Bath Whirlpools K-12106-H User Manual Page 10