Kohler Freewill Barier Free Bath Whirlpools K-12106-H User Manual download pdf (Page 13)

115982-2-BA (-)

Kohler Co., Kohler, WI

10. COMPLETE FINISH WALL

Install water-resistant wall material for either flush or

alcove installation as follows:

For flush installations: Install water-resistant wall

material to within 1/4” of the module edge. Install desired

trim around the unit to conceal the module edge. Also

install trim along the bottom apron edge.

Tape, mud, and finish the water-resistant wall material.

2x4 Studding

2” x 2” Brace

Acrylic Module

Water-Resistant

Wall Material

For alcove installations: Install water-resistant wall

material around the unit to conceal the module edge.

Tape, mud, and finish the water-resistant wall material.

2x4 Studding

2x2 Brace

Module

Water-Resistant

Wall Material

11. COMPLETE INSTALLATION

A. INSTALL WHIRLPOOL TRIM KIT

Refer to the installation instructions packed with the trim

kit when installing the jet or suction trim.

B. INSTALL FAUCET AND DRAIN TRIM

Install all finished faucet and drain trim according to

manufacturer’s instructions.

C. INSTALL EXTRA GRAB BARS

Any extra grab bars or towel bars should now be installed

through the module walls, and secured in place directly

to the bridging previously installed. Screws, bolts, and

backing should be selected to properly secure the grab

bars. Carefully seal around the grab bar fastener areas.

Follow the grab bar manufacturer’s instructions.

Grab bars can also be installed directly to the module,

providing the proper fastening device is selected to

securely attach the bar to the unit. Manufacturer’s

suggestions concerning grab bar installation must be

carefully followed.

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Kohler Freewill Barier Free Bath Whirlpools K-12106-H User Manual Page 13