Kohler Freewill Barier Free Bath Whirlpools K-12106-H User Manual download pdf (Page 5)

115982-2-BA (-)

Kohler Co., Kohler, WI

2. PRODUCT NOTICES

A. INSTALLER HAZARD NOTIFICATION

DANGER: Risk of fire, electric shock, or injury

to persons. Read important safety instructions on

inside front cover of these instructions.

WARNING: Risk of electrical shock. A licensed

electrician should make all electrical connections.

WARNING: Risk of electrical shock. Connect

only to a circuit protected by a Ground-Fault

Circuit-Interrupter (GFCI).

WARNING: Risk of electrical shock. Disconnect

power before servicing.

WARNING: Risk of injury or property damage.

Please read all instructions thoroughly before

beginning installation, including the following

Product Requirements.

NOTICE: Follow all local plumbing and electrical

codes.

B. FACTORY-ASSEMBLED FEATURES

Factory installed components include pump with integral

heater, control, and switch. No installation is needed.

The whirlpool pump and piping are factory-assembled.

WARNING: Unauthorized modification may

cause unsafe operation and poor performance

of the whirlpool. Do not relocate the whirlpool

pump, or make other modifications to the whirlpool

system, as this could adversely affect the

performance and safe operation of the whirlpool.

Kohler Co. shall not be liable under its warranty or

otherwise for personal injury or damage caused by

any such unauthorized modification.

3. PRODUCT REQUIREMENTS

A. SUMMARY OF KEY REQUIREMENTS

 Install unit to a level subfloor.

 Provide properly dimensioned framing.

 Recess installation is recommended.

B. PLUMBING SPECIFICATIONS

Confirm adequate mounting and connection space of

the faucet specified for your installation.

Confirm adequate support for the faucet; large faucets

that may be inadvertently used as a means of support

are not appropriate or safe for this installation.

In locations where plumbing is adjacent to a masonry

wall, make provisions for access to the connections.

Construct a separate wall a minimum of 6” from the

masonry wall. Install furring when the back of the unit is

against the masonry wall.

Because this is a one-piece unit, drain and overflow

connections cannot be made by reaching over the end

of the bath. Before installation, provide access to the

connections. See the Plumbing Access Considerations

section located on Page 8.

C. PRODUCT INSPECTION

Carefully unpack the whirlpool, remove the protective

tape, and and inspect the unit for damage. Leave all

materials in the carton during construction to prevent

damage.

NOTICE: Make sure both union connections to the

pump are securely tightened.

D. CONNECTIONS AND SERVICE ACCESS

Before installation, ensure proper access to the final

connections.

NOTICE: Provide unrestricted service access to the

pump. An access panel must be constructed to allow for

sufficient clearance for servicing the pump or controls.

The access panel must be located at the pump end of the

whirlpool.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Comments to this Manuals

No comments

Kohler Freewill Barier Free Bath Whirlpools K-12106-H User Manual Page 5

Comments to this Manuals

Related products and manuals for Water equipment Kohler Freewill Barier Free Bath Whirlpools K-12106-H