Kohler Purist Effervescent Bath K1191-LC User Manual download pdf (Page 12)

13. Using Your Bath

Fill the Bath

NOTE: Please read these steps carefully before you operate your bath.

NOTE: The water temperature in the bath should not exceed 104° F (40° C) or the heater will not operate.

IMPORTANT! Like any other bath, prevent ﬂooding the area around the unit by entering the ﬁlled

bathing well slowly. This will allow the system to properly drain excess water.

Fill the unit 4” (10.2cm) to 6” (15.2cm) from the bathing well rim.

Operating Sequence

Press the ″On/Off″ control switch to start the pump/motor and begin operation.

A green light in the ″On/Off″ control switch will turn on to indicate the start of the operating mode. The

light will remain green while the unit is running.

Verify that the indicator light for the heater is on when the unit is in operation. This indicator light is

located on the underside of the heater box, and is near the subﬂoor at the pump end of the unit.

If the light is not on when the unit is running, press the reset button located to the right of the indicator

light on the heater box.

Press the “On/Off” control switch again to turn off the bath. The “On/Off” control switch will turn off to

indicate the end of the operating mode.

NOTE: A built-in timer automatically stops the bath after approximately 20 minutes of operation.

Chromatherapy

Lights

1012493-2-A 12 Kohler Co.

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Kohler Purist Effervescent Bath K1191-LC User Manual Page 12