Cast Iron Baths & Whirlpools
For best results, keep the following in mind when caring for your KOHLER®
Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and dry any overspray
that lands on nearby surfaces.
Do not allow cleaner to soak.
Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean
For warranty information call 1-800-4KOHLER (1-800-456-4537).
* Success with cleaners and procedures is dependent upon such factors as the hardness and temperature of the
water, using exact measurements of ingredients, changes in cleaning formulas and the condition of the product being
cleaned. Since there are variations within these factors, Kohler cannot guarantee the effectiveness of the formulas.
Rinse thoroughly and use a soft cloth to wipe the product dry after each use.
In the rare occurrence of stub burn stains, use abrasive cleaners sparingly.
Do not use steel wool, wire brushes or abrasive sponge pads.
Use a soft nylon brush on the Safeguard surface, on the bottom of the bath.