Kohler K-15136-S-PB Installation Guide download pdf (Page 3)

2. Install the Threaded Spout

NOTE: The following instructions are for threaded spout

installations only. For slip-ﬁt spout installations, proceed to the next

section.

Remove the temporary nipple.

If you are installing the standard spout, apply thread sealant and

install a 1/2″ NPT nipple, extending 4″ (102 mm) beyond the

ﬁnished wall, to the bath elbow.

If you are installing the 8″ (203 mm) spout, apply thread sealant

and install a 1/2″ NPT nipple, extending 7-1/8″ (181 mm) beyond

the ﬁnished wall, to the bath elbow.

Apply a bead of plumbers putty or other sealant to the back of

the escutcheon according to the manufacturer’s instructions.

Apply thread sealant to the nipple, and install the spout to the

nipple.

Carefully tighten with a clean strap wrench.

Remove any excess putty.

Apply

plumbers

putty.

Standard Length Spouts

Threaded Spouts

Large Spouts

7-1/8"

(181 mm)

Nipple

(102 mm)

Nipple

Apply

plumbers

putty.

Kohler Co. 3 1011610-2-C

1 2 3 4 5 6 7 8 ... 11 12

No comments

Kohler K-15136-S-PB Installation Guide Page 3