Kohler SIPHON VORTEX LOW PROFILE ONE-PIECE TOILETS K-3402 User Manual download pdf (Page 9)

- 9 -

LUSTRA SEAT REMOVAL

1. Refer to Fig. #24. Pry up seat hinge post covers and

loosen screws. Remove wing nuts.

Lustra Seat Removal

Fig. #24

Seat Hinge Post

Covers

Screw

Wing Nut

2. Remove seat from toilet.

PILLOW TALK SEAT REPLACEMENT

1. Refer to Fig. #25. To install Pillow Talk toilet seat, slide

hex head bolts through holes in the two hinge blocks.

Slide bushings onto bolts.

2. Notice that the bushing and hinge block are serrated.

This allows you to adjust the toilet seat to the correct

position before tightening. Place toilet seat onto toilet

by inserting the hinge block/bushing assemblies

through the two holes on the toilet. Once the bushings

are inserted into the holes the toilet seat can be ad

justed. Adjust hinge block/bushing forward or back

ward until seat position is correct. Make sure the seat is

placed squarely on the toilet.

3. Thread wing nuts onto hex head bolts from underside

of toilet. An indentation on the hinge block will prevent

the hex head bolt from turning when the wing nut is

tightened.

4. Attach bolt covers as shown.

Pillow Talk Seat Replacement

Fig. #25

GENERAL TOILET TROUBLESHOOTING (ALL

MODELS)

If toilet won't shut off or is leaking, perform the following

procedure for initial troubleshooting, then refer to the ap

propriate chart on the following pages.

1. Shut off water supply. Note the water line inside the

tank.

2. Wait at least an hour and recheck the water level.

3. If the water level is at the top of the toilet's overflow tube

or has not dropped, the water level may be too high, or

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Kohler SIPHON VORTEX LOW PROFILE ONE-PIECE TOILETS K-3402 User Manual Page 9