Kohler Command Pro CV960 User Manual download pdf (Page 11)

Inspect and clean the oil cooler every 150 hours of

operation (more frequently under severe conditions).

Oil cooler must be kept free of debris.

To access and service the oil cooler, remove the top

mounting screw and loosen the two side screws, then

lift off the No. 2 side cylinder shroud. If required

remove the two screws holding the oil cooler to the

blower housing. Pull the cooler away from the blower

housing. Clean both sides of the cooler with a brush as

shown in Figures 17 and 18, or with compressed air.

After cleaning, reattach the oil cooler to the lower

blower housing with the two mounting screws.

Figure 16. Oil Cooler.

Figure 18. Cleaning Underside of Oil Cooler.

Air Cleaner

General

These engines use a heavy-duty style air cleaner

shown in Figure 19, consisting of a cylindrical housing

mounted to the carburetor and intake manifold. The

air cleaner housing contains a paper element and

inner element, designed for longer service intervals.

The system is CARB/EPA certified and the components

should not be altered or modified in any way.

Figure 17. Cleaning Top of Oil Cooler.

Figure 19. Heavy-Duty Style Air Cleaner.

Service

Weekly and every 150 hours: Check filter minder (if

equipped), unhook the two retaining clips on each end

and remove the end caps. Perform inspection of the

paper element and inlet screen area.

Seasonally or every 300 hours of operation (more

often under extremely dusty or dirty conditions),

replace the paper element and check the inner

element. Follow these steps.

1. Unhook the two retaining clips on each end and

remove the end caps from the air cleaner housing.

2. Check and clean the screen area on the inlet side.

Pull the air cleaner paper element out of the

housing on opposite side. See Figures 20 and 21.

Figure 20. Accessing Inlet Screen.

Oil Cooler

Inlet Screen

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

Kohler Command Pro CV960 User Manual Page 11