Kohler K-134 Series User Manual download pdf (Page 11)

Warranty (cont.)

*Never use cleaners containing abrasive cleansers, ammonia, bleach,

acids, waxes, alcohol, solvents or other products not recommended

for chrome. This will void the warranty.

Troubleshooting

Symptoms Probable

Causes

Recommended Action

1. No water

ﬂow.

A. Filter is

plugged.

A. Clean or replace the ﬁlter.

B. Sensor eyes

are dirty.

B. Wipe the sensor eyes with a

damp soft cloth. Wipe dry with a

dry soft cloth.

C. Water not

turned on.

C. Verify that the water supply is

turned on and that pressure is at

least 20 psi (137 kPa).

D. Incorrect

installation.

D. Verify that the faucet is mounted

as instructed in the installation

guide. Ensure that the sensor eyes

are above the rim of the sink. Refer

to the installation instructions.

E. The aerator

is plugged.

E. Remove and clean the aerator.

For calcium/mineral deposits, soak

the plastic insert in a 50:50 mix of

water and vinegar. Soak only the

plastic insert.

F. Sensor eyes

are scratched.

F. Replace the sensor assembly.

G. A ﬂex hose

is kinked.

G. Check the ﬂex hoses to make

certain they are not kinked. If a

ﬂex hose is kinked, disconnect it,

straighten, and reconnect.

H. Power was

interrupted.

H. Wait 2 minutes after power is

restored as the sensor cycles

through the automatic sensing

distance.

I. Battery life

expired.

I. Replace the power supply.

J. Bleed hole

in diaphragm

is plugged or

debris exists

on the seal.

J. Clean or replace the diaphragm.

Kohler Co. 11 1124215-5-C

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments

Kohler K-134 Series User Manual Page 11

Comments to this Manuals

Related products and manuals for Sanitary ware Kohler K-134 Series