Kohler K-18492-BN Installation Guide download pdf (Page 12)

7. Install Spout – Deck-Mount

Thread the tubes into the support plate.

Place a ﬁber washer and nut over the tubes, both above and

below the deck.

Hand tighten the nuts.

Verify the top of the tube is ﬂush with the surface of the intended

ﬁnished deck height.

Securely tighten the nuts with a wrench.

Solder a 1/2″ male copper connection (not supplied) to the

outside of a 12″ (30.5 cm) section of each water supply line.

Apply thread sealant to each male copper connection.

Securely tighten the coupling assemblies to each male copper

connection.

Connect the supply lines under the deck to the main water

supply.

Insert the plastic pipe plugs into the coupling assemblies.

Turn on the water supply.

Check all connections for leaks. Adjust as needed.

Turn off the water supply, then remove and discard the plastic

pipe plugs.

Finish the bath deck and surround.

Solder together.

Apply thread

sealant.

Nut

12"

(30.5 cm)

Fiber

Washer

Plug

Coupling Assembly

Male Copper Connection

Water Supply

Tubing

1054455-2-E 12 Kohler Co.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

No comments

Kohler K-18492-BN Installation Guide Page 12