Kohler K-301-K-NA Installation Guide download pdf (Page 4)

1. Prepare the Site

X=the distance from the centerline of the spout inlet base to the

front of the spout base plus 1/2″ (2.5 cm).

Y=the distance between the valve centerlines varies. Check the

handle and spout installation instructions for exact dimensions.

Install or relocate the water supplies as needed.

Protect the surfaces of the bath/deck during installation.

Ensure that holes drilled into the deck are not oversized. The

spout and valves require adequate base material strength and

maximum contact area with the deck.

NOTE: Reinforcing material may be required if the deck or rim is

thin. Install 1/2″ exterior grade plywood before proceeding.

NOTE: For installations to be covered with tile, the tile thickness

must not exceed 1-1/4″ (3.2 cm).

For installations with 8″ (20.3 cm) centers using copper tubing

(1/2″ nominal, 5/8″ OD), cut two 2-7/8″ (7.3 cm) pieces and one

2-3/8″ (6 cm) piece of tubing.

1-1/4" (3.2 cm) Max.

Tile Thickness

7/8" D.

5/8" O.D. Tubing (1/2" Nom.)

1-5/16" D.

7/8" D.

1-5/16" D.

Finished Deck And Rim Mount Roughing-In

Rough Deck Plus Finished Deck (Tile) Roughing-In

1/8" (3 mm) Min.

2-1/8" (5.4 cm) Max.

Rim Thickness

7/8" I.D.

(3/4" Nom.)

1/2" (1.3 cm) Min.

2-1/8" (5.4 cm) Max.

Deck Thickness

1-13/16"

(4.6 cm)

4-5/8"

(11.7 cm)

5-5/8"

(14.3 cm)

2-1/16"

(5.2 cm)

1/2" (1.3cm) Min.

2-1/8" (5.4 cm) Max.

Rough Deck

Thickness

5/8" O.D. Tubing

(1/2" Nom.)

7/8" I.D.

(3/4" Nom.)

113969-2-AB 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 39 40

Comments to this Manuals

No comments

Kohler K-301-K-NA Installation Guide Page 4

Comments to this Manuals

Related products and manuals for Sanitary ware Kohler K-301-K-NA