Kohler K-527-E-7 Installation Guide download pdf (Page 9)

Installation Checkout (cont.)

Verify that the water ﬂow is sufficient for your showering needs.

Troubleshooting

CAUTION: Risk of personal injury. The valve may contain

hot water; be careful when draining any residual water.

IMPORTANT! Turn off the power and water supply to the valve

before performing any maintenance.

NOTICE: Valve maintenance should be performed by a KOHLER

Authorized Service Representative.

This troubleshooting guide is for general aid only. For service and

installation issues or concerns, call 1-800-4KOHLER.

Troubleshooting Table

Symptoms Probable Cause Recommended Action

1. Control panel

is not lit.

A. Valve is not

plugged into the

outlet.

A. Plug the valve into

an outlet.

B. Interface cable

connections may

be loose or

disconnected.

B. Check all interface

cable connections,

connect if needed.

C. Circuit breaker has

been tripped.

C. Reset the circuit

breaker.

D. The valve memory

may require

resetting.

D. Disconnect and

reconnect the valve

power cord from the

electrical outlet.

E. A ″straight-

through″ cable or

coupler was used

to connect the

interface to the

valve.

E. Connect the interface

to the valve using a

″cross-over″ cable or

coupler.

F. If none of the

recommended

actions for the

above issues

correct the

symptom, the

valve or interface

requires servicing.

F. Contact your Kohler

Co. Authorized

Service

Representative.

Kohler Co. 9 1143086-2-E

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Comments to this Manuals

No comments

Kohler K-527-E-7 Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Sanitary ware Kohler K-527-E-7