Kohler K-9660-PB Installation Guide download pdf (Page 9)

116637-2-BC

Kohler Co., Kohler, WI U.S.A.

COMPLETE TRIM INSTALLATION – ALL

MODELS

Press the mixing valve knob onto the mixing valve stem

so the knob button and “104” mark face upward (toward

the escutcheon detent), as shown. Verify that the knob

does not rotate counterclockwise. Do not press the knob

button.

Turn on the water for a few minutes to allow the

temperature to moderate. Then use a thermometer to

check the water temperature. The water temperature

should be 104 F (40 C).

If the water temperature is 104 F (40 C), press the knob

button and rotate the knob fully counterclockwise so the

“120” mark faces upward. Check the water temperature

again. It should now be 120 F (49 C). Turn the knob

clockwise so the “104” mark is upward. Again check the

water temperature to make sure it is still 104 F (40 C).

Turn off the water.

If the water temperature does not match the temperature

indicated on the knob, repeat the mixing valve calibration

steps according to the “Adjust Temperature Settings”

section starting on Page 6.

Secure the mixing valve knob to the valve stem with the

screw. Install the thin O-ring into the first groove in the

knob. Carefully position the uninstalled grip ring into the

second groove in the knob.

Press the cap onto the valve so the cap detent is in line

with the knob button. If needed, apply a small amount of

the supplied silicone lubricant (capsule included in

hardware kit) to the inside wall of the cap to aid in

assembly.

Fig. #10

Mixing

Valve Knob

Mixing Valve

Stem

Screw

O-Ring

Grip Ring

Cap

Detent

Silicone Lubricant

(if needed)

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Kohler K-9660-PB Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Sanitary ware Kohler K-9660-PB