Kohler K-97339-NA Installation Guide download pdf (Page 7)

3. Install the Base

If attached, remove the faucet from the base.

Drill 1-1/2″ (380 mm) deep holes with a 3/16″ drill bit (provided)

using the marked locations as the center point.

If using concrete as the ﬂoor support, drill 1-1/2″ (380 mm) deep

holes with a 3/16″ masonry bit (not provided).

Realign the base to the position you marked. Make sure the cold

supply side notch is in the correct orientation.

Secure the base to the support with the screws and washers

provided.

Verify the base is level and tighten the screws.

Screw

Washer

Base

3/16"

Mounting Hole

Wood Support

Floor Joist

Kohler Co. 7 1240535-2-D

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

No comments

Kohler K-97339-NA Installation Guide Page 7