Kohler T45117-4-BN Installation Guide Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
4. Install Handles
Remove the plaster guards.
Measure the distance from the top of the valve stem to the finished surface.
For a valve stem height between 1-13/16 (4.6 cm) and 2-1/8 (5.4 cm) use a brass
spline adapter and screw. For a valve stem height between 2-1/8 (5.4 cm) and
2-5/16 (5.9 cm) use a plastic spline adapter.
If the brass spline adapter is required, attach using the screw supplied. The plastic
spline adapter slides on with no attachment.
Position the handle assemblies facing in opposite directions away from the spout.
NOTE: The spline adapter allows fine adjustment of the handle alignment. To adjust,
remove the handle and reposition the spline adapter.
Align the handle.
Reinstall the handle and check alignment.
Installer les poignées
Retirer les renforts en plâtre.
Mesurer la distance depuis le dessus de la tige de la valve à la surface finie.
Utiliser l’adaptateur à cannelures en laiton et la vis pour une hauteur de tige de
valve comprise entre 1-13/16 (4,6 cm) et 2-1/8 (5,4 cm). Utiliser l’adaptateur à
cannelures en plastique pour une hauteur de tige de valve comprise entre 2-1/8
(5,4 cm)]et 2-5/16 (5,9 cm).
Handle/Poignée/Manija
Screw/Vis/Tornillo
Apply plumbers putty.
Appliquer du mastic de plombier.
Aplique masilla de plomería.
Brass Spline Adapter
Adaptateur à cannelures en laiton
Adaptador de ranuras de latón
Plastic Spline Adapter
Adaptateur à cannelures en plastique
Adaptador de ranuras de plástico
Valve Stem
Tige de valve
Espiga de la válvula
Height Measurement
Hauteur
Medida de la altura
Finished Surface
Surface finie
Superficie acabada
Cold
Froid
Fría
Hot
Chaud
Caliente
Handle Orientation
Orientation de la poignée
Orientación de la manija
1158792-2-B 8 Kohler Co.
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments