Kohler K-1154-CC-0 Use and Care Manual download pdf (Page 6)

Warranty (cont.)

The Warranty will not be valid in the following cases:

1. When the product is not operated in accordance with the instructions concerning use and operation set

forth in the owner’s manual or installation instructions, and when the recommendations and warnings

included are not observed.

2. When the product has been modiﬁed or dismantled partially or totally; or has been used in a negligent

fashion and as a consequence has suffered damages attributable to the consumer, individual, or hardware not

authorized by Kohler Co.

3. This warranty does not cover the damages as a result of disaster such as ﬁre or acts of God, including

ﬂooding, earthquake, or electric storms, etc. To obtain a list of distributors in your area where you can

exercise your rights under this warranty, please call 001-800-456-4537.

KOHLER CO., KOHLER, WI 53044 U.S.A.

IMPORTER:

INTERNACIONAL DE CERÁMICA, S.A.B. DE C.V.

AV. CARLOS PACHECO NO. 7200

CHIHUAHUA, CHIH., MEXICO C.P. 31060

TEL: 52 (14) 29-11-11

Troubleshooting Procedures

This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or

qualiﬁed electrician should correct any electrical problems. For warranty service, contact your dealer or

wholesale distributor.

Troubleshooting Table

Symptoms Probable Causes Recommended Action

1. Whirlpool will not

start/stop.

A. No power to pump. A. Verify pump is plugged in and

the GFCI/RCD is not tripped.

Verify the outlet has power using

a multi-meter or by connecting a

110V item that you know is

working (lamp, radio, etc.) into

the outlet. Repair as needed.

B. Remove the access panel and

press the air switch, if you do not

hear a ″click,″ the air switch

tubing is loose or disconnected.

B. Check if the air switch tubing is

connected at both the

receiver/pump end and the air

switch. Reconnect if needed.

C. Air switch tubing is pinched or

kinked.

C. Adjust tubing to clear the

pinched/kinked area. If the

pinch/kink cannot be ﬁxed, or

no noticeable pinch/kink is

apparent, puncture the tubing

with a tack and try the system

again.

D. Push button assembly is damaged. D. Replace the push button

assembly.

E. Pump has power and a ″click″ is

heard when the air switch is

pressed. Pump is malfunctioning.

E. Replace the pump.

F. The receiver in the pump does not

work.

F. Replace the receiver or pump.

2. The system will start but

will not stay ON.

A. The receiver in the pump does not

work.

A. Replace the receiver or pump.

1010564-5-L 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments

Kohler K-1154-CC-0 Use and Care Manual Page 6

Comments to this Manuals

Related products and manuals for Space heaters Kohler K-1154-CC-0