Kohler K-487-CP Installation Guide download pdf (Page 7)

3. Install the Anchor

NOTE: You may need to disassemble some of the accessories. Some

accessories will be packed with the wall plate installed in the post.

Loosen the setscrew and remove the wall plate if needed.

Press and hold the legs of a wall anchor together, then insert the

wall anchor legs into the hole. Insert all wall anchors into the

pre-drilled mounting holes.

Carefully tap each wall anchor into the ﬁnished surface. Ensure

the wall anchors are ﬂush with the ﬁnished surface.

IMPORTANT! If the wall anchor was inserted into a space between

the studs, it will be necessary to spread the wall anchor legs. Insert

a thin, long object (such as a ﬁnishing nail) into the wall anchor hole

to spread the anchor legs. Repeat for all wall anchors inserted

between studs.

4. Install the Wall Plate

Orient the wall plate with the large slotted mounting hole down

and the smaller hole over the higher anchor.

Secure the wall plate with the supplied panhead screws.

Repeat at each wall plate location.

Nail

Install the Anchors

Install the Wall Plate

Anchor

Wall Plate

Panhead

Screws

Large Mounting

Hole

Kohler Co. 7 1020823-2-D

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

No comments

Kohler K-487-CP Installation Guide Page 7