Kohler K-1110-G-0 Installation Guide Page 5
- Page / 72
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Before You Begin (cont.)
Please read the installation, operating, and safety instructions carefully to familiarize yourself with
the required tools, material, and installation sequences. Follow the sections that pertain to your
particular installation. This will help you avoid costly mistakes.
The variety of installations possible with this bath may require framing procedures other than those
described in this manual.
Confirm adequate mounting and connection space for the faucet specified for your installation.
For Remote Installations
When mounting the blower motor and check valve in a remote location, choose a space as close to
the bath as possible to maximize bath performance. Pay attention to the following requirements and
recommendations:
•
The blower motor must be mounted horizontally at least 1-1/2″ (3.8 cm) above the floor. Do not
mount the blower motor with the blower motor discharge pointing up.
•
Use 1-1/2″ PVC or equivalent rigid piping.
•
The piping installation must meet the requirements of local plumbing or building codes. Ensure that
the installation does not reduce the fire rating of any walls. Piping must be supported at intervals
along the length in accordance with local codes.
•
Ensure that the blower motor location is clean and free of dust or debris.
•
If appropriate, install an additional access panel for blower motor maintenance.
•
The 18 AWG minimum power cable to the blower motor must meet the requirements of the
applicable electrical or building codes. Ensure that the installation does not reduce the fire rating of
any walls.
•
The power cord must be supported at intervals along its length in accordance with local codes.
Power cords must not rest on surfaces or floors that are subject to flooding.
•
All material needed for the relocation must be supplied by the installer.
Additional tools and materials:
•
Electrician pliers.
•
Assorted screwdrivers.
•
Adjustable wrench.
•
Drill and bits to install the blower mounting fasteners.
•
18 AWG non-metallic sheathed cable, two conductors with ground, with support clips, as required.
•
One 4″ (10.2 cm) x 2″ (5.1 cm) electrical junction box with cover, gasket, and mounting screws.
•
Three strain reliefs. One must fit the blower motor cover with standard NPT (National Pipe Thread)
threads. The other two must fit the holes in the new junction box.
•
Six wire connectors (wire nuts or equivalent).
•
1-1/2″ PVC or other rigid pipe with: fittings, unions, PVC cement (or equivalent fastening method),
and support clips, as required.
•
Four fasteners (such as flathead wood screws or concrete anchors) to mount the blower motor.
•
Solid copper 8 gauge bonding wire, 36″ (91.4 cm).
Kohler Co. reserves the right to make revisions in the design of products without notice, as specified
in the Price Book.
Kohler Co. 5 1035472-2-J
- Installation Guide 1
- IMPORTANT SAFETY INSTRUCTIONS 2
- Factory Assembled Features 3
- Table of Contents 4
- Tools and Materials 4
- Before You Begin 4
- Bath may be installed next 7
- 3. Secure the Bath 8
- 4. Install the Plumbing 9
- Electrician to provide 10
- Remove screws, remove cover 13
- 1035472-2-J 14 Kohler Co 14
- Second Junction Box 15
- Control Power Junction Box 15
- 11. Complete the Installation 17
- 12. Test Run the Bath 17
- 13. Operate the Keypad 20
- Troubleshooting 21
- Guide d’installation 24
- INSTRUCTIONS DE SÉCURITÉ 24
- Sommaire 26
- Outils et matériels 26
- Avant de commencer 26
- Panneaux 28
- 3. Sécuriser la baignoire 30
- 4. Installer la plomberie 31
- L'électricien doit 32
- Second boîtier de jonction 38
- 11. Terminer l’installation 40
- Dépannage 44
- Guía de instalación 48
- INSTRUCCIONES DE SEGURIDAD 48
- Contenido 50
- Herramientas y materiales 50
- Antes de comenzar 50
- Panel de 52
- La bañera se puede instalar 53
- 3. Fije la bañera 54
- 4. Instale la plomería 55
- (10,2 cm) del motor soplador 60
- Segunda caja de empalmes 62
- 11. Termine la instalación 64
- 13. Haga funcionar el teclado 67
- 1035472-2-J 71
Related products and manuals for Unknown Kohler K-1110-G-0
(4 pages)
Unknown Kohler K-9619-47 Installation Guide
(12 pages)
(12 pages)
Unknown Kohler K-1663-CP Installation Guide
(24 pages)
(24 pages)
Unknown Kohler K-716-47 Installation Guide
(20 pages)
(20 pages)
Unknown Kohler K-7223-BN Installation Guide
(32 pages)
(32 pages)
Unknown Kohler K-8023-BV Installation Guide
(20 pages)
(20 pages)
Unknown Kohler K-2354-8-7 Installation Guide
(16 pages)
(16 pages)
Unknown Kohler K-45410-AF Installation Guide
(12 pages)
(12 pages)
© 2020, manymanuals.com. All rights reserved. | 0.258 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals