Kohler K-14345-WF-96 Installation Guide Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
Troubleshooting Guide (cont.)
Symptoms Recommended Action
3. The fill valve
turns on/off
by itself
without the
toilet being
flushed, or it
runs, allowing
water to enter
the tank.
A. Adjust the flapper chain for proper slack so the flapper closes.
B. Clean or replace the flapper if it is worn, dirty, or misaligned
with the opening.
C. Clean the area around the opening to allow the flapper to seal.
D. Adjust the tank water level if it is too high.
E. Replace the fill valve if the valve float sinks.
4. Tank takes
excessive time
to fill.
A. Fully open the water supply shut-off valve.
B. Check the flexible supply line (if applicable) for a kink.
Remove the kink.
C. Clean the valve inlet, valve head, or supply line. Flush the
lines.
5. There is
excessive noise
when the tank
is filling.
A. Partially close the water supply shut-off valve if the water
pressure to the toilet is too high. Check the toilet performance
following any such adjustment.
B. Remove dirt or obstructions from the valve head. Flush the
lines.
Guide de dépannage
Symptômes Action recommandée
1. Faible chasse. A. Régler le niveau d’eau du réservoir au niveau du repère.
B. Ouvrir complètement la valve d’arrêt d’alimentation.
C. Dégager toutes obstructions du siphon, du jet ou des trous du
rebord de la cuvette.
D. Dégager toute obstruction de la ligne d’évacuation.
2. Pas de chasse. A. Raccorder la chaîne du clapet au levier de déclenchement ou à
la valve de chasse.
B. Régler l’assemblage de la chaîne du clapet pour éliminer tout
jeu excessif.
Kohler Co. 9 1068491-2-C
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments