Kohler K-1647-PC-G Installation Guide download pdf (Page 8)

3. Install the Steam Control

WARNING: Risk of personal injury. Do not install the Steam Control User Interface outside the

steam enclosure. The User Interface must be installed within the enclosure to allow the sensors to

regulate the temperature and control the ﬂow of steam.

Make sure that the power is turned off at the main breaker panel before proceeding.

Locate the control pad on the wall 60″ (152.4 cm) from the ﬂoor.

At the selected location, drill a hole 1-1/4″ (3.2 cm) in diameter.

NOTICE: Do not pinch, nail, wedge, or use undue force when handling the control connector and the

control pad wire. Any damage may result in control kit failure. If the control pad is not installed

immediately, protect the control connector with tape or other shielding material.

NOTICE: When installing the control kit, allow room in the control cable for a drip loop. The drip loop

will discourage moisture from following the control cable to the steam generator.

Pull the control connector from the steam generator through the drilled hole.

Carefully plug the control connector to the control pad wire using the double-end female connector

(provided).

Restore the power at the main breaker panel.

Turn on both water and power to the generator.

Test the control pad to ensure it is functioning properly. Refer to the ″Using the Control Pad″

section.

Apply a continuous bead of silicone sealant around the back edge of the control pad.

Press the control pad ﬁrmly onto the wall.

Apply a bead of silicone sealant around the outside edge of the control pad. Use tape to secure the

control to the wall while the sealant cures.

Allow the silicone sealant to cure for 24 hours before use.

Back View

Control Pad

Control Connector

Apply silicone sealant.

1-1/4"

(3.2 cm) D.

60" (152.4 cm)

to Floor

1045320-2-G 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

No comments

Kohler K-1647-PC-G Installation Guide Page 8