Kohler K-1663-CP Installation Guide download pdf (Page 5)

2. Install the Steam Head

WARNING: Risk of scalding. Do not locate the steam head near a seat or bench, as the steam head

is hot during operation and may scald the user if touched.

IMPORTANT! Do not obstruct the steam head with shut-off valves, plugs, or caps.

NOTE: The steam housing can be adjusted for a wall thickness of 3/16″ (5 mm) to 1-1/2″ (3.8 cm) using

the adjustment screws located on the steam head housing.

Position the gasket (provided) around the base of the steam housing so the gasket is between the

wall and the lip of the steam housing.

Turn the adjustment screws on the steam housing until the distance between the back edge of the

steam housing and the head of each adjustment screw is equal to the wall thickness.

Tighten the adjustment screws securely. Do not overtighten.

Secure the steam housing to the wall by carefully tightening the hold-down screws.

Thread the steam head clockwise onto the steam housing assembly until it is hand-tight.

Turn the steam head counterclockwise until the aromatherapy well is located at the 12 o’clock

position.

Apply thread sealant tape to the 1/2″ NPT male threads on the steam housing.

Push the steam housing assembly through the installation hole from inside the shower.

Complete the connection of the steam line to the steam housing.

Steam Head

1/2" NPT Elbow

Provide

clearance

from wall.

Steam Housing

Adjustment Screws

Steam Head

Gasket

Lip

Steam

Housing

Nipple

Aromatherapy

Well

Hold-Down

Screw

Wall

Kohler Co. 5 1008020-2-D

1 2 3 4 5 6 7 8 9 10 ... 23 24

No comments

Kohler K-1663-CP Installation Guide Page 5