Kohler K-2593-VBW-96 Installation Guide download pdf (Page 11)

6. Prepare the Cables

IMPORTANT! The cables that will connect the control ampliﬁer to the bath transducers, chromatherapy

control (if equipped), and the user interface are each 25’ (7.6 m) in length. Plan the location of the control

ampliﬁer so these cables, when routed and connected, will easily reach without placing tension on the

cables.

NOTE: The heated surface control is mounted to the board at the end of the bath.

Connect the larger Ethernet end of the user interface cable to one of the two ports on the heated

surface control.

Connect the inter-connect cable (both ends are Ethernet) for the ampliﬁer to the open port on the

heated surface control.

Carefully cut the cable tie securing the coiled transducer wires to the back of the bath.

Bind all electrical cables together to allow for easier routing through the shroud.

Inter-Connect

Cable

User Interface Cable

Heated

Surface

Control

User Interface

Transducer Wires

Control Board

Inter-Connect

Cable

Heated Surface

Control

Chromatherapy

Cable (If Equipped)

Optional Auxiliary-In

Cable

Drip

Loop

Kohler Co. 11 1237790-2-B

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

No comments

Kohler K-2593-VBW-96 Installation Guide Page 11