Kohler K-2607-F69 Installation Guide download pdf (Page 3)

Información importante (cont.)

Cumpla con todos los códigos locales de construcción.

Para ﬁjar correctamente el gabinete, se tiene que instalar material de refuerzo de

2x6 detrás de la pared acabada. Consulte las instrucciones de instalación del

tocador K-2604 para la preparación del lugar de instalación.

1. Install the Legs

IMPORTANT! Legs are not required for installation between two vanities.

NOTE: To protect the ﬁnished surface of the cabinet, perform assembly tasks on a

ﬂat, padded work surface.

Place the cabinet upright on a ﬂat, padded surface.

Remove the drawer to access the holes for leg attachment. Refer to the

″Remove/Reinstall the Drawer″ section of this guide.

Attach the Legs

For Installation to One Vanity Only: Determine whether the legs will be installed

on the left or right. The opposite side will be supported when installed to the

K-2604 vanity.

Lay the cabinet on its side and position each leg so the clips face toward each

other (as shown).

Secure each leg post using two #8 x 2″ panhead screws, lock washers, and ﬂat

washers.

Oriented as shown, position the cross rail above the clips between the front and

back legs.

Evenly press down on the cross rail until the clips are fully engaged. You may

need to apply slight pressure on each end until it clicks in place.

Screw

Vis

Tornillo

Cross Rail

Rail transversal

Riel transversal

Clip

Rear Leg

Pied arrière

Pata posterior

Front Leg

Pied avant

Pata frontal

Clip/Clip/Clip

Kohler Co. 3 1147373-2-B

1 2 3 4 5 6 7 8 ... 15 16

No comments

Kohler K-2607-F69 Installation Guide Page 3