Kohler K-2832-FF Installation Guide download pdf (Page 6)

Installation (cont.)

Waterproof any exposed areas of wood.

For Marble/Stone Countertops

Position the countertop upside down on foam padding to protect the surface.

Mark and drill 3/8″ holes 5/8″ (1.6 cm) deep at the locations shown on the

template.

Using a setting tool and hammer, secure the anchors.

For All Installations

If the countertop has not been installed, install it at this time.

Drill the faucet holes according to the faucet installation instructions.

Install the faucet and drain according to the manufacturer’s instructions.

NOTE: Do not use adhesives or adhesive sealants with this product. Only use

silicone sealant.

Apply a continuous bead of silicone sealant to the top surface of the lavatory rim

where it will contact the countertop.

For Marble/Stone Countertops: Install the lavatory to the countertop with the

clamps and anchor screws provided.

For Wood Countertops: Install the lavatory to the countertop with the clamps and

wood screws (not provided).

For Other Countertop Materials: Refer to the countertop manufacturer’s

instructions for recommended fasteners.

NOTICE: Risk of product damage. Do not overtighten the clamps. Overtightening

may cause irreparable damage to the lavatory.

Position the lavatory squarely under the cutout before tightening the clamps.

Draw the lavatory rim up against the countertop until it is snug. Do not

overtighten.

Immediately wipe away any excess sealant and ﬁll any voids as needed. Allow

the sealant to set for 30 minutes before proceeding.

Connect and tighten the trap to the drain. Complete the water supply connections

to the faucet according to the instructions packed with the faucet.

Run water into the lavatory and check for leaks.

Installation

Découper l’ouverture du comptoir en suivant avec précaution la ligne tracée du

gabarit.

REMARQUE: Utiliser les vis et les dispositifs d’ancrage fournis (les vis à bois ne sont

pas fournies) pour comptoirs d’une épaisseur minimale de 1″ (2,5 cm). Utiliser des

ancrages et des ﬁxations (non-fournis) pour des comptoirs plus minces.

Pour des comptoirs en bois

Marquer et percer les trous pilotes des vis à bois aux emplacements illustrés sur le

gabarit.

1120096-2-A 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Kohler K-2832-FF Installation Guide Page 6