Kohler K-3519-0 Installation Guide Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
De servicio Prepare el inodoro para el invierno (cont.)
Compruebe que no haya fugas, y vuelva a apretar las conexiones que presenten
fugas.
NOTA: Para más información consulte el manual de servicio del propietario de Sloan
Flushmate
®
.
Vuelva a activar
Vuelva a conectar la línea de suministro de agua al tanque. Luego abra el
suministro de agua y deje que el sistema se presurice durante un minuto como
mínimo.
Abra el suministro de agua, luego deje que el sistema se presurice durante un
minuto como mínimo.
Verifique que no haya fugas. Si aplica, vuelva a apretar las conexiones que
presenten fugas.
NOTA: Para más información consulte el manual de servicio del propietario de Sloan
Flushmate
®
.
Troubleshooting
NOTE: This troubleshooting guide is for general aid only. For warranty service,
contact your dealer or wholesale distributor.
Symptoms Recommended Action
1. Poor flush. A. Clean under the bowl rim.
B. Plunge the bowl, auger the trap, and auger the drain to clear any
blockage.
C. Reset the gap between the actuator and the plunger arm. Refer
to the Service Adjust Gap section.
D. Fully open the supply stop.
E. Clean the screen with a medium to hard bristle brush. Replace
the screen if necessary. (Phone 1-844-488-0669 (Spanish),
1-800-533-3450 (English) for assistance.)
F. Clean or replace the flow regulator.
G. Refer to installer/dealer for assistance.
2. No flush. A. Fully open the water supply stop.
B. Tighten the nut (turn counterclockwise to tighten).
C. Hook the plunger arm over the trip arm.
D. Clean the screen. (Phone 1-800-533-3450 for assistance.) Replace
the screen if necessary
E. Clean or replace the flow regulator.
F. Replace inlet components. (Phone 1-844-488-0669 (Spanish),
1-800-533-3450 (English).)
3. Bowl water
continues to
flow or tank
fill water will
not shut off.
A. Reset the gap between the actuator and the plunger arm. Refer
to the Service Adjust Gap section.
B. Repair or replace the plunger arm (refer to installer/dealer for
assistance).
C. Replace the lower supply group.
For additional assistance, also refer to the Sloan Flushmate
®
Owner’s Service Manual
supplied with the tank.
1115562-2-B 12 Kohler Co.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments