Kohler K-45903-2BZ Installation Guide download pdf (Page 12)

6. Install with Anchors

IMPORTANT! If the supplied toggle anchor fasteners are not used,

refer to section ″Before You Begin″ for fastener requirements.

NOTE: Anchor installation requires 1-7/8″ (48 mm) minimum

clearance behind the wall. The ﬁnished wall thickness must be a

minimum of 5/8″ (16 mm) and must be adequate in strength.

Install the Anchors

Drill two 1/2″ (13 mm) diameter holes for each mounting collar

at the pencil markings on the ﬁnished wall.

Hold the metal channel of the anchor ﬂat alongside the plastic

straps and slide the channel through the drilled holes.

Realign the handles of the straps to straighten the channel behind

the wall.

With one hand, pull the ﬁnger grips straight out (do not pull at

an angle) so that the metal channel rests ﬂush behind the wall.

Slide the clip along the straps with your other hand until the

ﬂange of the clip is ﬂush with the wall.

Drill 1/2" (13 mm)

holes at each

marked location.

1-7/8"

(48 mm)

1188076-2-A 12 Kohler Co.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

No comments

Kohler K-45903-2BZ Installation Guide Page 12