Kohler K-6816-BV Installation Guide download pdf (Page 5)

2. Mark and Drill the Pilot Holes

Draw a 1-3/8″ (3.5 cm) diameter circle around the accessory post

center point.

Position the wall plate over the circle and mark the three hole

locations.

NOTE: There is no provision for later adjustment if the center points

and the resulting pilot holes for multiple-post accessories are not

level with each another.

If your accessory requires multiple posts, verify the center points

are level.

NOTE: Use a 5/16″ drill bit for horizontal tissue holder installations.

Use a 1/2″ drill bit for all other accessory installations.

Set the wall plate aside, then drill a hole at each marked location.

Wall Plate Hole Locations

Wall Plate

Holes

1-3/8"

(3.5 cm) D.

11/16"

(1.7 cm) R.

Kohler Co. 5 1020822-2-B

1 2 3 4 5 6 7 8 9 10 ... 47 48

No comments

Kohler K-6816-BV Installation Guide Page 5