Kohler K-7147-AF-CP Installation Guide download pdf (Page 8)

1018154-2-B

Kohler Co.

Lift Rod

Loop

Lift Rod

Assembly

Hood

Assembly

6. Install Flush Hood

- Use a pliers to spread the top loop of the lift rod apart. Insert the end

of the loop into the hole in the end of the overflow hood lever. Close

the lift rod loop with a pliers.

- Insert the lift rod assembly, with attached hood, into the overflow

elbow.

- Install the hood by lifting it up and attaching the hood hinge to the

overflow elbow with the screws provided.

- Lift the hood to open the drain. The stopper should lift to

approximately 3/8” (1cm). If it does not, remove the lift rod

assembly.

- If the stopper does not lift high enough, use the adjusting screw to

adjust the spring downward. If the stopper lifts more than 3/8”

(1cm), adjust the spring upward.

7. Installation Checkout

- Ensure that all connections are tight.

- Open the drain.

- Turn on main water supply and check for leaks. Repair as needed.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

No comments

Kohler K-7147-AF-CP Installation Guide Page 8