Kohler K-9379-BN Installation Guide download pdf

CAUTION: Risk of product damage. In the following

step, do not overtighten or breakage may

occur.



 

115962-2-AA (-)

TOOLS AND MATERIALS REQUIRED:

 Phillips screwdriver

TO REMOVE EXISTING TRIP LEVER:

1. Remove tank cover.

2. Loosen nut securing trip lever to tank by turning clockwise.

The nut has left hand threads.

NOTE: In the following step, use care to prevent dropping

the nut into the vitreous tank. If the nut falls below

the water reservoir, it is not accessible.

3. Remove trip lever from tank while holding nut to prevent

dropping it into tank.

TO INSTALL NEW TRIP LEVER:

1. See Fig. #1. From outside the tank, insert trip lever arm

through hole in tank, sliding trip lever arm through the nut.

2. See Fig. #2. When seating the bushing against the outside

of the tank, position the trip lever arm below the plunger

arm.





3. See Fig. #2. Hand tighten the nut turning it

counter-clockwise. The nut has left-hand threads.

4. See Fig. #2. If necessary, loosen the setscrew and

re-adjust the plunger nut until there is a 1/16” gap between

the plunger nut and the plunger arm.

NOTE: If no gap is provided, the toilet will not shut off.

More then 1/16” gap may cause the flush to be too

short.

5. Replace tank cover.

Nut

Trip Lever

Bushing

Trip Lever Arm

Bearing

Surface

Trip Lever

Trip Lever Arm

Plunger Nut

Plunger Arm

1/16” Gap

Setscrew

Summary of Contents

Page 1 - 115962-2-AA (-)

CAUTION: Risk of product damage. In the followingstep, do not overtighten or breakage mayoccur.Copyright  1997 Kohler Co. 115962-2-AA (-)

Comments to this Manuals

No comments

Kohler K-9379-BN Installation Guide

Browse online or download Installation Guide for Unknown Kohler K-9379-BN. KOHLER K-9379-BN Installation Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Kohler K-9379-BN