Kohler K582 User Manual download pdf (Page 8)

Check Oil Level

The importance of checking and maintaining the

proper oil level in the crankcase cannot be

overemphasized. Check oil BEFORE EACH USE as

follows:

1. Make sure the engine is stopped, level, and is

cool so the oil has had time to drain into the

sump.

2. To keep dirt, grass clippings, etc., out of the

engine, clean the area around the oil fill tube

before removing it.

3. Remove the dipstick; wipe oil off. Reinsert the

dipstick and push it all the way down into the

tube.

4. Remove the dipstick and check the oil level.

The oil level should be up to, but not over, the F

mark on the dipstick. See Figure 6.

Operating

Range

F Mark

Figure 6. Oil Level Dipstick.

5. If the level is low, add oil of the proper type, up to

the F mark on the dipstick. (Refer to Oil Type

on page 4.) Always check the level with the

dipstick before adding more oil.

NOTE: To prevent extensive engine wear or

damage, always maintain the proper oil

level in the crankcase. Never operate

the engine with the oil level below the L

mark or over the F mark on the

dipstick.

Oil Sentry

Some engines are equipped with an optional Oil

Sentry oil pressure switch. If the oil pressure

decreases below an acceptable level, the Oil Sentry

will either shut off the engine or activate a warning

signal, depending on the application.

NOTE: Make sure the oil level is checked BEFORE

EACH USE and is maintained up to the F

mark on the dipstick. This includes engines

equipped with Oil Sentry.

Change Oil and Oil Filter

Change Oil

For a new engine, change oil after the first 5 hours

of operation. Thereafter, change oil after every 50

hours of operation.

Change the oil while the engine is still warm. The oil

will flow freely and carry away more impurities. Make

sure the engine is level when filling, checking, or

changing the oil.

Change the oil as follows:

1. Remove the oil drain plug. Tilt the engine slightly

towards the oil drain to obtain better drainage.

2. Reinstall the drain plug. Make sure it is tightened

securely.

3. Fill with new oil of the proper type to the "F" mark

on the dipstick. Always check the level on the

dipstick before adding more oil.

NOTE: To prevent extensive engine wear or

damage, always maintain the proper oil

level in the crankcase. Never operate

the engine with the oil level below the L

mark or over the F mark on the

dipstick.

Change Oil Filter

Replace the oil filter every 100 hours of operation.

Always use a genuine Kohler oil filter, Part No.

277233.

Replace the oil filter as follows:

1. Drain the crankcase oil first, then remove the old

oil filter. Use a 1" hex. wrench and turn the filter

counterclockwise to remove.

2. Place a new replacement filter in a shallow pan

with the open end up. Pour new oil of the proper

type, in through the threaded center hole. Stop

pouring when the oil reaches the bottom of the

threads.

3. Put a drop of oil on your fingertip and wipe it on

the rubber gasket. Allow a minute or two for the

oil to be absorbed by the filter material then

install it on the engine.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

Comments to this Manuals

No comments

Kohler K582 User Manual Page 8

Comments to this Manuals

Related products and manuals for Engine Kohler K582