Kohler K-1418-HE-96 Installation Guide download pdf (Page 4)

1. Preparation

NOTICE: Measure your product for site preparation. Note the model number located on the pump, then

visit the product page at www.kohler.com for more information.

NOTICE: Provide generous, unrestricted access to the pump. You must provide access for servicing the

pump and controls. The access must be located immediately next to the pump.

NOTICE: Do not lift the whirlpool by the piping or pump, or use the piping or pump for structural

support of the whirlpool. To avoid damage to the whirlpool, lift at the sides of the whirlpool.

NOTICE: Do not support the load weight of the whirlpool by the rim.

NOTE: Drop-in, alcove, or corner installation is possible, depending on the product chosen.

NOTE: The product model number is printed on a label on the pump side of the whirlpool bath.

Carefully unpack and inspect the new whirlpool for damage before installation. If there is damage

do not install the whirlpool; contact your dealer.

Make sure the ﬂooring offers adequate support for your whirlpool, and verify that the subﬂoor is

ﬂat and level.

Construct 2x4 stud framing.

Install an access panel for future pump servicing. The access panel must be at least 20″ (508 mm)

wide by 15″ (381 mm) high.

Install the rough plumbing.

Install the drain to the whirlpool according to the drain manufacturer’s instructions.

Protect the whirlpool surface by positioning a clean drop cloth in the basin bottom.

Access

Panel

Construct according

to the product dimensions.

Construct 2x4

stud framing

according to the

roughing-in

information.

Position the

rough plumbing.

Verify that the subfloor

offers adequate support,

and is flat and level.

Alcove Drop-In

Position

the rough

plumbing.

Verify that the subfloor

offers adequate support,

and is flat and level.

1194658-2-A 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 51 52

No comments

Kohler K-1418-HE-96 Installation Guide Page 4