Kohler K-T10581-4-CP Installation Guide download pdf (Page 7)

3. Water Temperature Adjustment

CAUTION: Risk of personal injury. The water temperature

should never be set above 120° F (49° C).

NOTE: Do not remove the O-ring and collar at this time. Removing

the O-ring and collar will change the factory setting for the

maximum water temperature.

For minor water temperature changes:

Adjust the setscrew.

To check for signiﬁcant water temperature changes, turn the valve

clockwise to the full open position and let the hot water run for

several minutes.

Position a thermometer in the water stream. The water

temperature should never be set above 120° F (49° C).

For major water temperature changes:

Remove the O-ring and collar from the stem. Slowly rotate the

valve stem until the water temperature is as desired.

Reinstall the collar on the valve stem so the setscrew is against

the side of the tab.

Reinstall the O-ring and rotate the valve stem counterclockwise to

shut the water off. Recheck the water temperature.

NOTE: After installation, complete the required information on the

valve label.

O-Ring

Setscrew

Tab

Collar

Setscrew

Valve

Label

Standard

Valve

High Flow

Valve

Stem

Kohler Co. 7 1036173-2-A

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

No comments

Kohler K-T10581-4-CP Installation Guide Page 7