Kohler Bath with Airjets 1199249-2-A User Manual download pdf (Page 12)

8. Make Power Connections - Remote

WARNING: Risk of electric shock. To reduce the risk of electric shock, connect the control to a

properly grounded Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device (RCD). This

will provide additional protection against line-to-ground shock hazard. A dedicated 220-240 V, 20 A,

50/60 Hz circuit is required.

WARNING: Risk of electric shock. Make sure the power has been disconnected before performing

the following procedures.

Ensure that the control power supply cord is properly routed to the control power junction box. The

control power supply cord contains a brown wire (Line 1), a blue wire (Line 2), and a green wire

with a yellow stripe (ground or earth).

Install a strain relief (not provided) for the power supply cable to the control power junction box.

Route the power supply cable to the control power junction box.

As required, strip the jacket and wire insulation on both cables to make the connections.

For installations in the USA, mark any white conductor in the supply power wiring with red or

black tape as required by the NEC.

Connect service to the control power junction box.

Provide a separate equipment earthing or grounding conductor to the spare earth/ground lug

located on the control power junction box. This conductor must not be connected to any

current-carrying conductor. Follow local electrical codes.

Bond in accordance with national and local codes.

Clean the area of all dust and debris.

All wiring harnesses have been pre-wired at the factory. Ensure that all wires are securely fastened.

NOTE: Your wiring harness includes an antenna for the optional remote control. Do not alter or damage

this antenna during installation.

9. Complete the Installation

Test Run the Bath

Fill the bath to a level at least 4″ (102 mm) above the top of the highest airjet.

Operate the bath for 5 minutes and check all bath piping connections for leaks. Check for leakage

along the front, sides, and back of the bath.

For additional information on bath operation, see the ″Operating Instructions″ section.

Power Supply Cable

Blower Motor Cord

Control Power Supply

Control Power Junction Box

Second Junction Box

(added for Remote Blower)

Check Valve

New Field Cable To Blower Motor

Typical Remote Blower Installation

Remote Blower

1199249-2-A 12 Kohler Co.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

No comments

Kohler Bath with Airjets 1199249-2-A User Manual Page 12