Kohler K-610-6B-KB Installation Guide download pdf (Page 4)

2. Supply Tee Installation

From the underside of the lavatory, thread the shank nut about

halfway up onto the spout shank. Slide the metal washer onto the

spout shank.

Insert the plastic gasket and the rubber washer into the supply

tee.

Slide the metal washer onto the spout shank.

Thread the supply tee onto the spout shank until hand tight.

Ensure that the arms of the supply tee are aligned to face the left

and right sides of the lavatory.

Tighten the hex end of the supply tee with a wrench. Do not

overtighten.

Slide the metal washer down to the supply tee and thread the

shank nut down to the metal washer. Securely tighten with a

wrench. Do not overtighten.

Slide the O-ring over the guide tube and securely tighten the nut

to the supply tee sleeve with a wrench. Do not overtighten.

Slide the O-ring all the way up the lift rod.

Securely hand tighten the nut on the lift rod until a desired

resistance is achieved.

Supply Tee

Supply Inlet

O-Ring

Guide Tube

Metal Washer

Shank Nut

Rubber Washer

Spout Shank

Plastic Gasket

Tee Hex-End

Guide Tube Nut

1000959-2-B 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 39 40

No comments

Kohler K-610-6B-KB Installation Guide Page 4